Follow these guides to add the dongle to your network:

Step 1: Creating a Bever account
Step 2: Installing & login in the Bever App
Step 3: Authorizing & adding a device to a network : (beverinnovations.com) 

Step 4: Creating a site and assigning a map

Step 5: Adding devices to a group and configuring

Once the devices are added to your preferred network, it's time to access your device settings. Click on the device you wish to configure.



Before you start configuring settings, ensure you have preemptively clicked on "Get Data".


In the Basic en Advanced menu, you'll find various options to customize the behavior of your dongle:


Basic

NameValuesDescriptionDefault
Dali Bridge ModeON/OFFDALI to EOS (off) / EOS to DALI (on)
OFF
Repeat DALI command[0-20]Amount of informs0
Use Logarithmic output levelON/OFFOutput LevelON


Output power[0-100]%Maximum output level100%



EOS to Dali: External motion interpretation

Time to dimHOURS/MIN/SECTime it takes to dim2 MInutes
Dim saving[0-100]%Percentage that should dim of the output70%
Use deepdimON/OFFuniform dimmingOFF
Time to deepdimHOURS/MIN/SECTime to deepdim (dim lvl 2)5 Minutes
Deep-dim saving[0-100]%Percentage that should deep-dim of the output100%

Dali to EOS

Startup percentage [0-100]%Percentage of startup output0%
Use logarithmic output level ON/OFFOutput LevelOn
Networks to informNetworks available Which available networks should informed Own network
Send new percentage[0-300]At which intervals a new percentage is set10 ms
Numbers of hops[0-20]Number of hops between devices3x


Advanced

NameValuesDescriptionDefault
EOS
Device network identifier[1-30]Network ID of Bridge
1
Use external antennaON/OFFThe use of an external antennaOFF
EOS to Dali
Output offset[0-100]%
0%
Attended timeoutHOURS/MINUTES
0
Motion priority[0-20]
7x
Use max with equal priority ON/OFF
OFF
Same level priority[0-20]
100
Always use latest level (ignore priority)ON/OFF
OFF
Ignores EOS to DALI group mapping, just broadcastON/OFF
OFF